DR. MILLETT

Below are videos and step-by-step directions on how to set up cases for Dr. Millett and how to use / troubleshoot equipment that he commonly uses.

SCOPE CASES

Arthrex Tablet Patient Input

  1. Make sure that the Arthrex Box is turned ON first
  2. Press the "user normal" button on the tablet to log into the software
  3. Press "New Patient" button in the upper right part of the screen
  4. Input the following information:
    • First / Last Name
    • MRN
    • Doctor Name
    • Procedure Type
  5. Press either "SAVE" or "START CASE" depending on if you want to input more patients or start that case directly
  6. Make sure to go to the nurse touchpanel and press "ARTHREX" and tap all the screens that you want the scope video routed to
  7. Dr. Millett's cases AUTOPRINT to the printer in the PACU once the case is finished. Give it a minute and then go check over there to make sure they are printing

Tablet Settings

  1. To check the settings, press the settings button on left side of the screen
  2. You can then adjust the brightness, zoom, prints, etc.

Click for more ARTHREX tablet related videos

Re-Printing a Previous Case

  1. Press the button that has the image of the file folder in upper right side
  2. From there you can select the patient you're looking for and press "review"
  3. The patient page will open and you can then print or save to a USB
  4. To print you just press the "Print" butto below and then you will be asked to chose the images per page and copy amount

Click for more ARTHREX tablet related videos

Setup Checklist

  1. Is the Patient Information plugged into the ARTHREX tablet?
  2. Is the video from the scope routed to desired monitors in the room?
  3. Have you started recording the case? (after white balance)

Post-Case Checklist

  1. Get Prints from the Printer in PACU
  2. Print off pictures from the Mini-C Arm or Large C-Arm if used

Click for more Large C-Arm videos