1. Plug the microscope into a RED outlet
2. Take the HDMI Cable and plug it into the Boom 2n1 panel
• Make sure to do the loop around the pillar to avoid strain on the HDMI cable during case
3. Turn ON the microscope from the switch down towards the bottom
4. Go over to the Nurse Touchpanel and route to the monitors you need

---

1. Make sure that the camera box is ON (light will be lit green)
2. From here you can change the brightness by pressing the "gain" or the arrow buttons

You can mess around with the settings on this box without affecting the surgeons' view. It will only change what is seen on the monitors in the room.

---

1. Plug the microscope into a RED outlet
2. Take the HDMI Cable and plug it into the Boom 2n1 panel
• Make sure to do the loop around the pillar to avoid strain on the hdmi cable during case
3. Turn ON the microscope from the switch down towards the bottom
4. Go over to the Nurse Touchpanel and route to the monitors you need

---

1. Make sure that the camera box is ON (light will be lit green)
2. From here you can change the brightness by pressing the "gain" or the arrow buttons
3. You can use the dial to select and adjust color settings as needed

You can mess around with the settings on this box without affecting the surgeons' view. It will only change what is seen on the monitors in the room.

---

1. Plug the microscope into a RED outlet
• Do this with BOTH of the plugs
• One of the plugs gives power to the microscope and the other gives power to the camera box
2. Take the HDMI Cable and plug it into the Boom 2n1 panel
• Make sure to do the loop around the pillar to avoid strain on the hdmi cable during case
3. Turn ON the microscope from the switch down towards the bottom
4. Go over to the Nurse Touchpanel and route to the monitors you need

---

1. Make sure that the camera box is ON (light will be lit green)
2. From here you can change the brightness by pressing the "gain" or the arrow buttons
3. You can use the dial to select and adjust color settings as needed

You can mess around with the settings on this box without affecting the surgeons' view. It will only change what is seen on the monitors in the room.

---

1. Adjusting the colors on the Microscope: find the camera box that is on the microscope
2. Microscope isn't showing up on the montiors in the room? Make sure that the HDMI cable is plugged into the Wall Aux or Boom Aux and it is selected and routed on the nurse touchpanel to the desired monitors.

---

1. Is Microscope ON?
2. Is the HDMI plugged in?
3. Is the video from the scope routed to desired monitors in the room?

---