DR. FORD

Below are videos and step-by-step directions on how to set up cases for Dr. Ford and how to use / troubleshoot equipment that he commonly uses.

GI SCOPE SETUP

GI Tower Setup

Make sure that the GI tower is plugged in and turned on
Plug in the HDMI cord into the Boom or Wall Aux
Route to ALL the monitors in the room AND the AIDA
Input the Patient information into the AIDA
Do a test capture when the case starts to make sure that images are being captured on the AIDA

ROBOTIC CASE SETUP

Aida Patient Input

Dr. Ford will want to record some of his cases so just make sure to ask and see if you need to press record on the AIDA for him

Go over to the Aida and input the Patient Information
First Name, Last Name, MRN, Doctor
Turn ON the Stryker boxes that are on the Boom
Go over to the Nurse Touchpanel and route to ALL the screens in the room

LAPAROSCOPIC CASES

Stryker Scope / Aida Setup

Go over to the Aida and input the Patient Information
First Name, Last Name, MRN, Doctor
Turn ON the Stryker boxes that are on the Boom
Go over to the Nurse Touchpanel and route to ALL the screens in the room

Click for more detailed videos and walkthroughs on the AIDA

Printing Images

Go over to the Aida and press "Finish"
This will automatically print the images for the case

Click for more detailed videos and walkthroughs on the AIDA

Aida Re-Printing

Select the file cabinet button in top right side of screen
Look for the patient name that you need and select the box on the right left side
Make sure to print with the "Standard" button layout selected

Printer Problem Checklist

Is Printer ON?

Make sure light is on and power cord is plugged into the back

Is there paper in the printer?

Check the paper holder and get paper if needed

Has the case been ended?

Make sure to press "Finish" at the end of the case to send to the printer

Click for more detailed videos and walkthroughs on the printer you are using