OLYMPUS

Below are videos and step-by-step directions on how to set up cases for Dr. Hammaker and how to use / troubleshoot equipment that he commonly uses.

GI SCOPE SETUP

GI Tower Setup

  1. Make sure that the GI tower is plugged in and turned on
  2. Plug in the HDMI cord into the Boom or Wall Aux
  3. Route to ALL the monitors in the room AND the AIDA
  4. Input the Patient information into the AIDA
  5. Do a test capture when the case starts to make sure that images are being captured on the AIDA

Printing Images

  1. Go over to the Aida and press "Finish"
  2. This will automatically print the images for the case

For videos on the Printers click here

Aida Re-Printing

  1. Select the file cabinet button in top right side of screen
  2. Look for the patient name that you need and select the box on the right left side
  3. Make sure to print with the "Standard" button layout selected

For videos on the AIDA click here

Printer Problem Checklist

  1. Is Printer ON?
    • Make sure light is on and power cord is plugged into the back
  2. Is there paper in the printer?
    • Check the paper holder and get paper if needed
  3. Has the case been ended?
    • Make sure to press "Finish" at the end of the case to send to the printer
  4. Is there a red error light coming from the the button below the power button?

Click for more detailed videos and walkthroughs on the printer you are using